View Full Version : where is the thermastat on a 98 subaru 2.5 rs?
02-13-2008, 05:39 AM
i cant figure it out and im new to this make of a vehicle
02-14-2008, 10:06 AM
Drain some coolant into a clean container until the coolant level is below the thermostat housing. Remove the upper radiator hose connection from the thermostat housing. Loosen the housing bolts and remove the housing. Remove the gasket and scrape it carefully from the surface of the housing and the mounting surface on the engine. If the gasket remains on either of the surfaces, there will probably bea coolant leak after reassembly. Some engines use a rubber O-ring to seal a thermostat housing. Compare the size of the thermostat to the old one. They are of different sizes, types, and temperature ratings. The temperature rating is stamped on the sensing bulb on the bottom of the thermostat. The temperature bulb faces the block. When replacing a thermostat, be sure that the thermostat fits into the groove in the block or outlet housing. If the thermostat is installed upside down, the engine will overheat. Install the gasket. Reinstall the thermostat housing. Refill the system and run the engine or pressure test to check for leaks. When the engine has reached operating temperature make sure the thermostat opens. You should be able to see coolant circulating within the radiator. Another way of checking thermostat operation is to feel the top of the radiator hose or use a thermometer or multimeter with a temperature probe to confirm that the coolant is warming up. If the engine is overheating, but the top hose is still cool to the touch, the thermostat is stuck closed and must be replaced.
02-15-2008, 02:33 PM
IT'S IN THE LOWER HOSE. Where the lower hose connects to the engine ( right at the water pump) you'll see a housing. It has 2 or 3 bolts, the t/stats in there.
02-16-2008, 06:59 PM
Like the person above said, it's on the water pump and there is not gasket to scrape. There is a rubber gasket that goes around the stat itself, just make sure you replace it too. .....AND, when you fill the system back up. Take the upper hose off at the rad, fill the engine up slowly and then reinstall the hose and fill the rad up slowly to prevent air pockets.
Powered by vBulletin® Version 4.2.2 Copyright © 2014 vBulletin Solutions, Inc. All rights reserved.